<span id="fpn9h"><noframes id="fpn9h"><span id="fpn9h"></span>
<span id="fpn9h"><noframes id="fpn9h">
<th id="fpn9h"></th>
<strike id="fpn9h"><noframes id="fpn9h"><strike id="fpn9h"></strike>
<th id="fpn9h"><noframes id="fpn9h">
<span id="fpn9h"><video id="fpn9h"></video></span>
<ruby id="fpn9h"></ruby>
<strike id="fpn9h"><noframes id="fpn9h"><span id="fpn9h"></span>

基于LMI的魯棒H容錯動態輸出反饋控制設計

Design of robust H fault-tolerant output feedback control based on LMI

  • 摘要: 針對線性不確定系統,研究了其執行器失效情況下魯棒容錯H動態輸出反饋控制設計問題.基于連續型執行器故障模型,利用線性矩陣不等式(LMI)方法提出了線性不確定系統動態輸出反饋H容錯控制器存在的充分條件,給出了動態輸出反饋H控制器的設計方法.所獲得的控制器不僅能使故障系統魯棒穩定,并且能達到給定的H性能指標.仿真實例證明了所提出設計方法的有效性.

     

    Abstract: For linear uncertain systems with actuator faults, the problem of robust fault-tolerant H dynamic output feedback control was studied. Based on an actuator failure model with continuous gain, the sufficient condition for dynamic output feedback H robust fault-tolerant controllers was proposed by using a linear matrix inequality (LMI) approach, and the corresponding design method of a dynamic output feedback H controller was given. The proposed controller not only enables the system to keep robust stabilization but also achieves the given H performance. A simulation experiment shows that the proposed method is effective.

     

/

返回文章
返回
<span id="fpn9h"><noframes id="fpn9h"><span id="fpn9h"></span>
<span id="fpn9h"><noframes id="fpn9h">
<th id="fpn9h"></th>
<strike id="fpn9h"><noframes id="fpn9h"><strike id="fpn9h"></strike>
<th id="fpn9h"><noframes id="fpn9h">
<span id="fpn9h"><video id="fpn9h"></video></span>
<ruby id="fpn9h"></ruby>
<strike id="fpn9h"><noframes id="fpn9h"><span id="fpn9h"></span>
www.77susu.com