<span id="fpn9h"><noframes id="fpn9h"><span id="fpn9h"></span>
<span id="fpn9h"><noframes id="fpn9h">
<th id="fpn9h"></th>
<strike id="fpn9h"><noframes id="fpn9h"><strike id="fpn9h"></strike>
<th id="fpn9h"><noframes id="fpn9h">
<span id="fpn9h"><video id="fpn9h"></video></span>
<ruby id="fpn9h"></ruby>
<strike id="fpn9h"><noframes id="fpn9h"><span id="fpn9h"></span>

GH33A合金熱機械循環塑性性能

Thermal Mechanical Cyclic Plastic Bebavior of GH33A Supperalloy

  • 摘要: 針對GH33A高溫合金材料在溫度與機械應變同時交變條件下的熱機械循環塑性性能,就相位差對該材料在熱機械循環狀態下的循環硬化、循環軟化和疲勞壽命的影響進行分析和討論.結果表明:相位差影響材料的循環硬化與軟化;在570~825℃的溫度交變條件下,同相熱機械疲勞壽命比反相熱機械疲勞壽命短。

     

    Abstract: The cyclic plastical bebavior of GH33A supperalloy is investigated under the condition of simultaneous cycle of temperature and mechanical strain. Influance of phase difference of alternating temperature and mechanical strain(in-phase and out-of-phase) on cyclic softening or cyclic hardening and thermal mechanical fatigue life is studied. The experimental results show that the damage in in-phase thermal machanical fatigue is more serious than that in out-of-phase at 570~825℃.And, the material is serious cyclic softening at high temperature side and first cyclic hardening, then cyclic softening at low temperature side for both in-phase and out-of-phase in thermal mechanical fatigue.

     

/

返回文章
返回
<span id="fpn9h"><noframes id="fpn9h"><span id="fpn9h"></span>
<span id="fpn9h"><noframes id="fpn9h">
<th id="fpn9h"></th>
<strike id="fpn9h"><noframes id="fpn9h"><strike id="fpn9h"></strike>
<th id="fpn9h"><noframes id="fpn9h">
<span id="fpn9h"><video id="fpn9h"></video></span>
<ruby id="fpn9h"></ruby>
<strike id="fpn9h"><noframes id="fpn9h"><span id="fpn9h"></span>
www.77susu.com